Difference between revisions of "Wind turbine"
(Created page with "{{Block |blockname=Wind Turbine |requirements=None |image=Stone Heat Furnace |poweredby=Wind (No fuel required) |type=Multiblock |stackable=Yes }}The '''Wind Turbine''' provid...") |
|||
| Line 6: | Line 6: | ||
|type=Multiblock | |type=Multiblock | ||
|stackable=Yes | |stackable=Yes | ||
| − | }}The '''Wind Turbine''' provides power at ~50v (Depending On Wind Power) either direct to other blocks or via [[Cable]]. | + | }} |
| + | THIS ARTICLE IS STILL WORK IN PROGRESS!!! | ||
| + | The '''Wind Turbine''' provides power at ~50v (Depending On Wind Power) either direct to other blocks or via [[Cable]]. | ||
==Crafting== | ==Crafting== | ||
Revision as of 20:06, 12 November 2016
| Block type: | Multiblock |
| Powered by: | Wind (No fuel required) |
| Requirements for operation: | None |
| Stackable: | Yes (64) |
THIS ARTICLE IS STILL WORK IN PROGRESS!!!
The Wind Turbine provides power at ~50v (Depending On Wind Power) either direct to other blocks or via Cable.
Contents
Crafting
Stone Heat Furnace
Interface
Internal/External Control (A)
If set to internal control, you can move the Gauges yourself. If set to external, the Gauges are controlled by a signal coming in over a Signal Cable.
Take/Decline Fuel (B)
If under Internal control, this controls whether the Furnace will consume fuel. If it is left off, the furnace won't consume any fuel.
Regulator Slot (C)
Normally only the Control Gauge can be controlled. If you have a Regulator installed, you can set a particular temperature for the furnace to hold. The Analog Regulator does so gradually, finding the exact right control setting, while the 1%/10% regulators work approximately like a standard thermostat.
Combustion Chamber Slot (D)
At least 1 Combustion Chamber is needed for the Stone Heat Furnace to work. Add a second to improve efficiency.
Fuel Slot (E)
Insert combustible fuel here.
Temperature Gauge (F)
Shows the current temperature of the furnace. Requires a regulator to be able to be controlled.
Control Gauge (G)
Sets the rate at which to burn fuel in %. At a setting under 10%, no fuel will be burned, and the Furnace is effectively off.
