200V example build

Differences from 50V

The 200V startup build is very similar to the 50V example build.

• We now need to use the 200V Medium Voltage Cable, of course
• The 50V Heat Turbine is replaced by the 200V Heat Turbine (blue)
• the 50V machines are replaced by 200V machines. (blue)

Voltage control

• Using external control, obviously we need to set the Voltage range to something nearer to 200V instead of 50V
• Note that it is relatively safe to over-volt the line a little. Just beware not to over-amp.

• (If you're using an Analogic Regulator, 350 degrees celcius is roughly correct)

Finally

Spot the differences with the 50V version!

Where next

You now have a good jumping off point for the other Examples

You could consider building the Autominer example.