Difference between revisions of "200V example build"
From Electrical Age
(→Finally: == Where next ==) |
(→Finally) |
||
| Line 22: | Line 22: | ||
Spot the differences with the 50V version! | Spot the differences with the 50V version! | ||
| + | |||
[[Image:Example_200V_4.png|800px]] | [[Image:Example_200V_4.png|800px]] | ||
| − | |||
== Where next == | == Where next == | ||
Revision as of 03:57, 6 November 2016
Differences from 50V
The 200V startup build is very similar to the 50V example build.
- We now need to use the 200V Medium Voltage Cable, of course
- The 50V Heat Turbine is replaced by the 200V Heat Turbine (blue)
- the 50V machines are replaced by 200V machines. (blue)
Voltage control
- Using external control, obviously we need to set the Voltage range to something nearer to 200V instead of 50V
- Note that it is relatively safe to over-volt the line a little. Just beware not to over-amp.
- (If you're using an Analogic Regulator, 350 degrees celcius is roughly correct)
Finally
Spot the differences with the 50V version!
Where next
You now have a good jumping off point for the other Examples
You could consider building the Autominer example.
