Difference between revisions of "Transmitter Antenna"
From Electrical Age
(+Img) |
|||
| (23 intermediate revisions by 3 users not shown) | |||
| Line 2: | Line 2: | ||
|blockname=Low/Medium/High Power Transmitter Antenna | |blockname=Low/Medium/High Power Transmitter Antenna | ||
|image=Transmitter | |image=Transmitter | ||
| − | |type= | + | |type=Single |
| − | |poweredby= | + | |poweredby=Varied Voltages |
|requirements=None | |requirements=None | ||
}} | }} | ||
| − | Transmitter | + | '''Transmitter''' antennas allow you to beam power across the air, to be collected at a reverse-facing '''receiver''' antenna. They have a limited range, and become less efficient the further the distance. Typical ranges are 200m-300m. |
| Line 13: | Line 13: | ||
==Crafting== | ==Crafting== | ||
| + | |||
| + | 50v Transmitter | ||
| + | {{Crafting_Grid | ||
| + | |1=Redstone |3=Iron_Ingot | ||
| + | |4=Cheap_Chip |5=Iron_Plate | ||
| + | |7=Redstone |9=Iron_Ingot | ||
| + | |result= }} | ||
| + | |||
| + | 200v Transmitter | ||
{{Crafting_Grid | {{Crafting_Grid | ||
| − | |1= | + | |1=Cheap_Chip |3=Iron_Plate |
| − | |4= |5= | + | |4=Advanced_Chip |5=Iron_Plate |
| − | |7= | + | |7=Cheap_Chip |9=Iron_Plate |
|result= }} | |result= }} | ||
| + | 800v Transmitter | ||
| + | {{Crafting_Grid | ||
| + | |1=Advanced_Chip |3=Iron_Plate | ||
| + | |4=Advanced_Chip |5=Iron_Plate | ||
| + | |7=Advanced_Chip |9=Iron_Plate | ||
| + | |result= }} | ||
| + | ""TODO"": Finish | ||
| + | 50v Receiver | ||
| + | |1=Iron_Ingot |3=Iron_Ingot | ||
| + | |5=Cheap_Chip |6=Iron_Plate | ||
| + | |7=Redstone |9=Iron_Ingot | ||
| + | |result= }} | ||
== Ranges == | == Ranges == | ||
| Line 39: | Line 60: | ||
== input/output == | == input/output == | ||
| − | You can send a signal from the receiver to the transmitter. Typically you'd use this to control the throttle on the transmitter end. | + | You can send a signal from the receiver to the transmitter. Typically you'd use this to control the throttle on the transmitter end. This can be especially useful if the receiving end no longer requires power or otherwise gets disconnected from the network as an overloaded receiver will fail. |
=== Receiver Antenna === | === Receiver Antenna === | ||
| − | * S | + | [[File:Receiver connections.png|150px|float|right|thumb|A receiver antenna with S and P visible.]] |
| − | * P | + | |
| + | * '''S'''ignal: You can set a signal here and it will be sent to the transmitter. | ||
| + | * '''P'''ower: Power comes from here. The component will fail if it receives more power than it can handle. | ||
| + | {{-}} | ||
=== Transmitter Antenna === | === Transmitter Antenna === | ||
| − | * S | + | [[File:Transmitter connections.png|150px|float|right|thumb|A transmitter antenna with S,C,P visible.]] |
| − | * C | + | * '''S'''ignal: A received signal from the receiver. Can be used to control the throttle, to prevent the receiver from receiving more power than it can handle. |
| − | * P | + | * '''C'''ontrol: Throttle to determine how much power to transmit. Shuts off at 0v. |
| + | * '''P'''ower: Power goes into this, and is transmitted in the direction of the dish, hopefully to be caught by a receiver! | ||
| + | Higher power transmitters can set things on fire. | ||
| + | {{-}} | ||
| Line 59: | Line 86: | ||
[[Category:Blocks]] | [[Category:Blocks]] | ||
| + | [[Category:50 Volts]] | ||
| + | [[Category:200 Volts]] | ||
| + | [[Category:800 Volts]] | ||
Latest revision as of 22:49, 21 June 2018
Low/Medium/High Power Transmitter Antenna
| Block type: | Single |
| Powered by: | Varied Voltages |
| Requirements for operation: | None |
| Stackable: | Yes (64) |
Transmitter antennas allow you to beam power across the air, to be collected at a reverse-facing receiver antenna. They have a limited range, and become less efficient the further the distance. Typical ranges are 200m-300m.
Crafting
50v Transmitter
200v Transmitter
800v Transmitter
""TODO"": Finish
50v Receiver |1=Iron_Ingot |3=Iron_Ingot |5=Cheap_Chip |6=Iron_Plate |7=Redstone |9=Iron_Ingot |result= }}
Ranges
| Type | Voltage | Max Range |
|---|---|---|
| Low Power | 50V | 200m |
| Medium Power | 200V | 250m |
| High Power | 800V | 300m |
- Power drops over distance.
input/output
You can send a signal from the receiver to the transmitter. Typically you'd use this to control the throttle on the transmitter end. This can be especially useful if the receiving end no longer requires power or otherwise gets disconnected from the network as an overloaded receiver will fail.
Receiver Antenna
- Signal: You can set a signal here and it will be sent to the transmitter.
- Power: Power comes from here. The component will fail if it receives more power than it can handle.
Transmitter Antenna
- Signal: A received signal from the receiver. Can be used to control the throttle, to prevent the receiver from receiving more power than it can handle.
- Control: Throttle to determine how much power to transmit. Shuts off at 0v.
- Power: Power goes into this, and is transmitted in the direction of the dish, hopefully to be caught by a receiver!
Higher power transmitters can set things on fire.
