Difference between revisions of "Inductor"

Revision as of 00:40, 10 January 2017

Inductors are a type of storage which tries to keep current flowing through it consistently by storing electricity when current is high, and discharging when current is low. When current passes through it, it will store a little of it within a magnetic field at the cost of some voltage. If the current dies out, the inductor try to keep the flow going by releasing its its charge. It acts similar to capacitor, though you will lose all your saved power if you disconnect it and unlike a capacitor the released current faces the same way as the input current did.

These require copper wires and a Ferromagnetic Core. The amount of copper wire inserted will set its inductance and the core will determine how much energy is wasted from the process.

When the circuit is open, the power flows through the main loop, accumulating charge. When the circuit is closed, it will loop around the secondary wire until it runs out of power.

Tips on usage

Inductors will store a LOT of power if you give them a very fast current. If you want to use an inductor for storage purposes, be sure to step up the current as much as you can get away with. This comes at the cost of speed as a low voltage inductor will charge/discharge very slowly. Remember to step the current back down before reintroducing the power into your network, or you may instantly incinerate your wires with the tremendous amperage.

Installing your Inductor

Once you place down the Inductor, you still need to install a few components for it to run. First, place in a feromagnetic core. Higher quality cores will waste less energy. Next, add in copper cables to set the inductance. You can install up to 19 cables for a max of 10H.

Inductance Values

• 100mH
• 150mH
• 220mH
• 330mH
• 470mH
• 680mH
• 1H
• 1.5H
• 2.2H
• 3.3H
• 4.7H
• 6.8H
• 10H